Edge Ovens EDGE40 Installation & Operating Manual page 41

Daily Maintenance
•
Clean the exterior of the oven using a mild detergent solution and a soft cloth.
Always clean in the direction of the grain to avoid visible scratches.
•
Clean the glass window in the half-bake door using a soft cloth and mild detergent
solution.
•
Remove and clean all crumb pans.
Monthly Maintenance
•
Clean the exterior of the oven using a mild detergent solution and a soft cloth.
Always clean in the direction of the grain to avoid visible scratches.
•
Clean the glass window in the half-bake door using a soft cloth and mild detergent
solution.
•
Remove and clean all crumb pans.
•
Clean the conveyor using a stiff-bristle nylon brush to remove loose debris and food
particles.
•
Remove the main fan motor cover, vacuum out any debris lodged in the motor
cooling ports, then reinstall the cover.
Quarterly Maintenance
•
Perform all monthly maintenance tasks.
•
Remove the conveyor drive chain cover and drive chain.
•
Remove the conveyor belt assembly from the bake chamber.
•
Remove the oven end plugs.
•
Ensure that each finger is marked and is listed on the finger location decal so that
each finger can be reinstalled in the proper location.
•
Vacuum the inside of the bake chamber to remove all loose debris.
•
Clean the inside of the oven, the oven end plugs, and the conveyor drive chain cover
using a soft cloth and a mild detergent solution. Do not immerse in water.
•
If possible, clean the oven fingers and conveyor assembly outside using a pressure
washer or steam cleaner. These components can also be cleaned using a stiff-
bristle nylon brush and a mild detergent solution.
•
Allow all removed components to dry thoroughly before reinstallation.
•
Reinstall components into oven:
– Reinstall fingers in appropriate locations.
– Reinstall oven end plugs.
– Reinstall the conveyor belt assembly.
– Reinstall the conveyor drive chain and drive chain cover.
EDGE40 / EDGE60 Installation and Operating Manual
37 Rev 1.1 December 04, 2008