Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Oven installation must comply with local codes or, if local codes do not exist,
with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
This appliance must be electrically grounded in accordance with local codes, or if
local codes do not exist, with the National Electrical Code, ANSI/NFPA 70.
When this appliance is installed with casters, it must be installed with the casters
supplied, a connector complying with ANSI Z21.69, a quick-disconnect device
complying with ANSI Z21.41, and a mechanism to limit movement of the
appliance without straining the connector or its associated piping system.
Oven installation must comply with local codes or, if local codes do not exist, gas
oven installation must comply with the Natural Gas Installation Code, CAN/CGA-
B149.1, or the Propane Gas Installation Code, CAN/CSA-B149-2, as applicable.
This appliance must be electrically isolated in accordance with local codes, or if
local codes do not exist, with the Canadian Electrical Code, CSA C22.2.
When this appliance is installed with casters, it must be installed with the casters
supplied, a connector complying with CAN/CGA-6.16, a quick-disconnect device
complying with CAN-6.9, and a mechanism to limit movement of the appliance
without straining the connector or its associated piping system.
This appliance and its individual manual shutoff valves must be disconnected
from the gas supply piping system during any pressure testing of gas supply
piping at pressures exceeding 1/2 psi (3.5 KPa).
The installer of this oven must contact local building and fire officials concerning
inspections and installation requirements of this oven and its ventilation system.
EDGE40 / EDGE60 Installation and Operating Manual
IMPORTANT
US CUSTOMERS
IMPORTANT
CANADIAN CUSTOMERS
NOTE
NOTE
6
Rev 1.1 December 04, 2008
Hide quick links:
Advertisement
Table of Contents
