Table of Contents
Advertisement
13. Firmly tighten all bolts passing through the oven top.
14. Reinstall the insulation in the oven top.
Do not place your hands or fingers under the connecting lip. The edge of the
connecting lip is sharp and can cause severe cuts or perhaps loss of a finger.
15. Lift and set the oven assembly on the oven base. Ensure that the connecting lip fits
over the oven base.(Figure 10)
16. Lift the control can into position, and run the two thermocouple leads into the hot air
plenum through the small hole provided.(Figure 11)
EDGE40 / EDGE60 Installation and Operating Manual
WARNING
Figure 10
Figure 11
14
Rev 1.1 December 04, 2008
Hide quick links:
Advertisement
Table of Contents
