Edge Ovens EDGE40 Installation & Operating Manual page 21

Installation Instructions – Finger Assemblies (Options #1 and #2)
1. All EDGE ovens are shipped with a total of eight (8) finger assemblies per oven.
Each finger assembly consists of three (3) parts:
2. Your finger assemblies have been shipped from the factory with a set pattern based
on the type of product to be baked. In most cases, the only difference will be the
inner columnating panel. Refer to the finger location decal located on the front of
your oven to determine which finger assembly to place in each finger position of your
oven.
3. Working from the control side of the oven, set the first pair of upper and lower finger
assemblies into place by sliding them into the oven with the narrow end slightly
raised (to avoid the front finger holders). Align the wider (open) end of the finger
over the finger opening in the plenum wall, and lower the narrow end into the front
finger holder.(Figure 16)
EDGE40 / EDGE60 Installation and Operating Manual
A. Housing
B. Inner Columnating Panel
C. Outer Cover
B
A
Figure 15
17
C
Rev 1.1 December 04, 2008