Table of Contents
Advertisement
Installation Instructions – Option #2 (Installer-Assembled)
TOOLS REQUIRED:
(1) 9/16 socket or wrench
(1) 7/16 socket or wrench
(1) Set of alignment tools (supplied)
(1) Phillips screw driver
(1) Slotted screwdriver
1. Remove all items from the shipping crate. Inspect each item for shipping damage
before continuing.
2. For single- or double-stack installation only, install the casters onto the oven legs.
(Figure 3)
3. For single- or double-stack installation only, install the oven legs (with casters) onto
the oven base. For triple-stack installation only, install the casters directly onto the
oven base.(Figure 4)
4. Set the oven base assembly flat on its casters near the final installation area.
The oven back is shipped assembled to protect the blower motor fan from
damage during shipping.
Be careful not to bend or otherwise damage the blower fan. Any damage to the
blower fan will result in premature failure of the blower motor bearings.
5. Locate the oven back (hot air plenum with blower motor and fan). Remove the 3/8-
16 x 3/4 bolts holding the oven back (blower motor/fan assembly) to the plenum,
then separate the oven back and plenum assemblies. Set the blower motor/fan
assembly and hardware aside for use later.
The hardware kit included with your oven contains alignment tools and all
hardware necessary to assemble your oven.
During assemble; use the alignment tools in the smaller punched holes to locate
proper placement of components. Leave the mounting bolts snug, but do not
tighten fully, until all bolts are installed. This will help align all components
properly.
6. Set the hot air plenum on a level work surface with plenum finger face facing up.
7. Set the oven bottom onto the plenum (connecting lip facing up), align the mounting
holes, and secure it to the plenum using 3/8-16 x 3/4 bolts.
EDGE40 / EDGE60 Installation and Operating Manual
NOTE
CAUTION
NOTE
12
Rev 1.1 December 04, 2008
Hide quick links:
Advertisement
Table of Contents
