8. Set the oven front (half-bake window upside down) under the other end of the oven
bottom, align the mounting holes, and secure it to the oven bottom using 3/8-16 x
3/4 bolts. (Figure 8)
9. Fully tighten all bolts passing through the oven bottom.
10. Turn the partially assembled oven over.
11. Remove the insulation from the oven top and set it aside. Note how the insulation
was installed to aid reinstallation.
12. Set the oven top (connecting lip facing up) onto the plenum/oven bottom/oven front
assembly, and align the mounting holes. Secure it to the plenum and oven front
using 3/8-16 x 3/4 mounting bolts and alignment pins.(Figure 9)
EDGE40 / EDGE60 Installation and Operating Manual
Figure 8
Figure 9
13
Rev 1.1 December 04, 2008