Cleaning The Water Tank - Electrolux EOB6850 User Manual

34 www.electrolux.com
Installing the door and the glass panel

11.5 Cleaning the water tank

WARNING!
Do not put water into the water
tank during the cleaning proce-
dure.
During the cleaning procedure,
some water can drip from the
steam inlet onto the cavity of the
oven. Put a dripping pan on the
shelf level directly below the
steam inlet to prevent water from
falling onto the bottom of the oven
cavity.
After some time, you can have lime de-
posits in your oven. To prevent this, clean
the parts of the oven that generate the
steam. Empty the tank after each steam
cooking.
1. Fill in the water tank with 900 ml of
water and 50 ml of citric acid (five
teaspoons). Deactivate the oven and
wait for approximately 60 minutes.
2
1
10. Carefully lift (step 1) and remove (step
2) the glass panels one by one. Start
from the top panel.
11.
Clean the glass panels with water
and soap. Dry the glass panels care-
fully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of
the door. Make sure that after the installa-
tion the surface of the glass panel frame
on the screen-printing zones is not rough
when you touch it.
Make sure that you install the middle pan-
el of glass in the seats correctly (refer to
the illustration).
2. Activate the oven and set the True
Fan + Steam function. Set the tem-
perature 230 °C. Deactivate it after 25
minutes and let it cool down for 15
minutes.
3. Activate the oven and set the True
Fan + Steam function. Set the tem-
perature between 130 and 230 °C.
Deactivate it after 10 minutes. Let it
cool down and continue with the re-
moval of the tank contents (refer to
"Emptying the water tank").
4. Rinse the water tank and clean the
remaining lime residue in the oven
with a cloth.
5.
Clean the drain pipe by hand in warm
water with soap. To prevent damage,
do not use acids, sprays or similar
cleaning agents.
Types of water
• Soft water with low lime content -
the manufacturer recommends this be-
cause it decreases the quantity of
cleaning procedures.