Dss Buttons - Toshiba Strata IPT User Manual

STRATA IPT/DKT FEATUREPHONE USER GUIDE
DSS Console
The Direct Station Selection (DSS) console operates alongside an IP or digital featurephone to
provide 60 additional buttons. The Strata DKT3000- series featurephones requires a 3000- series
DSS; the 2000-series featurephone requires a 2000-series DSS. A DDSS3060 example is shown
right. The IDSS2060 (not shown) looks similar and has the same button/LED functions.
Note:
The IP featurephones do not support a DSS console when connected to a Strata CTX
The 60 flexible feature buttons can be assigned as CO line, extension, DSS, One Touch Speed
Dial or any other flexible feature.
The DDSS3060 console uses dual red and green LEDs to show call and feature status.

DSS Buttons

DSS buttons can appear on both the ADM and DSS S button is associated with a particular station
in your telephone system. DSS buttons can transfer an outside call to the associated station or
make a direct call to the associated station. The DSS LED lights steady red when the station
associated with the DSS button is ringing, busy on a call, or when the associated station is idle, but
all appearances of the station's extensions are busy or in-use by other stations. When the
associated DSS button is in the Do Not Disturb mode, the LED blinks red at a slow rate.
DSS buttons cannot call station Phantom extension numbers, Distributed Hunt Group Directory
Numbers, or ACD Groups. DSS buttons may be configured as One Touch Buttons that may be
programmed to call these destinations.
The LED colours described in this section apply to the DADM3020 and DDSS3060. Described
Flash conditions apply to all DSS console models and the DADM.
105 of 124
Toshiba Business Communications Division