Direct Station Selection Buttons (Hotline); Distinctive Ringing - Toshiba Strata IPT User Manual

Direct Station Selection Buttons (Hotline)

This optional feature enables you to use a
extension. The DSS LED shows the status (idle/busy) of the station and/ or the station's primary
extension. For example, a station's DSS button LED shows busy (light steady red) when the station
is:
• busy on a call on any button
• idle but all appearances of the station's extension are in use by other stations. When the station is
in DND, the LED flashes red.
To connect directly to another station's extension
1. When connected to a line or another station, press
The original party is put on-hold. You can call a station even if the DSS LED
shows busy (steady red).
2. Announce the call...or transfer the call by hanging up or pressing
Note:
You can transfer the call to an idle or busy station.

Distinctive Ringing

To set distinctive ringing (CTX software R1.2 or lower)
#9876
1. Press to enter User Programming Mode.
Line
2. Press a button. The Line LED is steady green.
3. Enter the ringing pitch number:
11 12
= Low, = Middle,
4. Lift the handset to return to idle.
To set distinctive ringing (CTX software R1.3 or higher)
#9876
1. Press to enter User Programming Mode.
Line
2. Press a or extension button. The LED is steady green
Hold
3. You can press
station calls within your system; external = outside line calls.)
4. Enter the two-digit pitch number (see table):
5. Press the same button that you pressed in Step 2 (
confirmation tone and "DATA PROGRAMMED" displays on your LCD.
STRATA IPT/DKT FEATUREPHONE USER GUIDE
DSS
13 14
= High, = Combination
to switch between internal and external pitch. (Internal =
button to connect directly to another station's line
DSS
.
Release
Line
or extension). Two beeps is a
Toshiba Business Communications Division
.
58 of 124