Setting Tam Mode - Canon EB15 User Manual

Setting TAM MODE

Setting TAM MODE allows you to receive telephone messages and fax transmissions while the fax
is unattended. When you cancel TAM MODE, any new telephone messages will be played
automatically.
Follow the procedure below to set TAM MODE.
1
Press [TAM] to set TAM MODE.
• When you set TAM MODE, the TAM LED lights up
and the outgoing message is played. When you
cancel TAM MODE, the TAM LED switches off. If
you have any new telephone messages, the
messages are played automatically.
• To cancel TAM MODE, press [TAM] again.
• NO OGM is displayed on the LCD when no outgoing message has been recorded. You must record
n
an outgoing message before you can set TAM MODE. (see p. 8-2)
• A maximum of 50 messages, including an outgoing message, alternative message and voice memos,
with a total maximum recording time of 10 minutes can be recorded. You can set a maximum
recording time of 120 seconds for each telephone message. (see p. 8-4)
• The date and time when the telephone message was recorded, the number of telephone messages and
the number of the message being played (ICM No.) are displayed whenever a message is played.
When TAM MODE is set and a call is received, the fax will respond as described below.
1
The fax will ring 2 or 5 times, w
is set to ON, depending on whether there are
any telephone messages. (see p. 8-5)
When TOLL SAVER is set to OFF, you can specify
the number of times the fax will ring.
2
The outgoing message is played to the other
party.
3
If the other party sends a fax after they leave a
message, or if the call is a fax call, the fax is
received automatically.
n When the fax is set to MANUAL MODE and MAN/AUTO SWITCH has been set to OFF, TAM
MODE will be activated if the fax rings 15 times and the call is not answered. When the call is
disconnected, the fax returns to MANUAL MODE.
hen TOLL SAVER
TAM MODE ON
Ex:
15:00 :00
8 8
8-3