Table of Contents
Advertisement
Redialling when the line is busy
There are two methods of redialling: manual redialling and automatic redialling. This section
explains these two methods.
Manual redialling ______________________________
Press [Redial/Pause] to dial the last number you dialled with the numeric buttons. (This starts
redialling regardless of whether automatic redialling is enabled.)
Cancelling manual redialling
To cancel manual redialling, press [Stop].
Automatic redialling ___________________________
What is automatic redialling?
When you are sending a document using memory sending and the receiving party's line is busy, the
fax waits the specified time and then dials the same number again. You can set the fax to redial
several times if previous attempts fail because of a busy signal. This feature is called automatic
redialling.
After the initial dial attempt, the fax is factory-set to wait two minutes and then try to dial again. If
the second attempt fails because the line was busy, the fax will again wait for two minutes and make
a final attempt to complete the call.
Automatic redialling can be turned off and on. The number of redialling attempts and the time
interval between attempts can also be adjusted. (see AUTO REDIAL, p. 9-4)
If all redialling attempts are unsuccessful, the fax will cancel the transmission and print an ERROR
TX REPORT to remind you that the transmission was not completed. (see p. 9-12)
When automatic redialling is in use, the LCD alternately displays AUTO REDIAL and the
transaction number (TX/RX NO. xxxx) while it is waiting to redial.
6
6-9
Advertisement
Table of Contents
