Table of Contents
Advertisement
2.4 Setting Jumpers
You may configure your card to match the needs of your application by
setting jumpers. A jumper is a metal bridge used to close an electric cir-
cuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To "close" a
jumper, you connect the pins with the clip. To "open" a jumper, you
remove the clip. Sometimes a jumper will have three pins, labeled 1, 2
and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
open
The jumper settings are schematically depicted in this manual as follows:
open
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes.
Generally, you simply need a standard cable to make most connections.
2.5 Installing SO-DIMMs
The procedure for installing SO-DIMMs is described below. Please fol-
low these steps carefully. The number of pins are different on either side
of the breaks, so the module can only fit in one way. SO-DIMMs modules
closed
closed
11
closed 2-3
closed 2-3
Chapter 2 Installation
Advertisement
Table of Contents
