Denso AT27Q-SB User Manual page 62

2d code handy scanner

Table of Contents

(Note 1) GS1 DataBar (RSS) represents: GS1 DataBar Omnidirectional (RSS-14), GS1 DataBar Truncated (RSS-14

Truncated), GS1 DataBar Limited (RSS-14 Limited), GS1 DataBar Stacked (RSS-14 Stacked), GS1 DataBar

Expanded (RSS Expanded), GS1 DataBar Stacked Omnidirectional (RSS-14 Stacked Omnidirectional), and GS1

DataBar Expanded Stacked (RSS Expanded Stacked).

(Note 2) These code ID marks are contained in code data.

(Note 3) Type 4 is a code ID mark system compliant with the AIM USA "Guidelines on Symbology Identifiers." The "m"

suffix is a modifier character that differs depending upon options of individual symbologies as defined below.

Code Type

QR Code

codes

iQR Code

MaxiCode

Data Matrix

Aztec

Interleaved

Bar

2of5

codes

Code 39

Code 39 Full

ASCII

Codabar

Code 128

Example: The code ID mark for Interleaved 2of5 with option "Scanning enabled, with a check digit (Check digit

transmission disabled)" is ]I3.

]: Flag character (ASCII 93h)

I: Code character (Interleaved 2of5)

3: Modifier character (See the table above.)

(Note 4) For code ID marks not compliant with the AIM USA "Guidelines on Symbology Identifiers," same characters as

ones defined in Type 1 apply.

"m"

(Modifier

character)

Model 1

Model 2

No FNC1 in the 1st character positions from start code

FNC1 in the 1st character positions from start code

FNC1 in the 2nd character positions from start code

mode 4, mode 5

mode 2, mode 3

ECC-200

ECC-200 (FNC1 in the 1st or 5th character position from start code)

ECC-200 (FNC1 in the 2nd or 6th character position from start code)

No options

FNC1 preceding the 1st message character

FNC1 subsequent to the 1st character or digit pair

Scanning enabled, without a check digit