Table of Contents
Advertisement
S
S
UPER
ERVER 5016I-T/5016I-TF User's Manual
2-5
Checking the Serverboard Setup
After you install the 5016I-T/5016I-TF in the rack, you will need to open the unit
to make sure the serverboard is properly installed and all the connections have
been made.
Accessing the Inside of the System (Figure 2-5)
1.
First, grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
2.
Next, depress the two buttons on the top of the chassis to release the top
cover. There is a large rectangular recess in the middle front of the top cover
to help you push the cover away from you until it stops.
3.
You can then lift the top cover from the chassis to gain full access to the
inside of the server.
Checking the Components
1.
You may have one or two processors already installed into the system board.
Each processor should have its own heatsink attached. See Chapter 5 for
instructions on processor and heatsink installation.
2.
Your 5
016T-TB server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
3.
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
4.
Make sure all power and data cables are properly connected and not blocking
the airfl ow. See Chapter 5 for details on cable connections.
5.
Check the air seals for damage. The air seals are located under the blower
fan and beneath the frame cross section that separates the drive bay area
from the serverboard area of the chassis.
2-8
Advertisement
Table of Contents
