Table of Contents
Advertisement
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Note: Due to memory allocation to system devices, the amount of memory that
remains available for operational use will be reduced when 4 GB of RAM is used.
The reduction in memory availability is disproportional.
For Microsoft Windows users: Microsoft implemented a design change in Windows
XP with Service Pack 2 (SP2) and Windows Vista. This change is specifi c to the
Physical Address Extension (PAE) mode behavior which improves driver compatibil-
ity. For more information, please read the following article at Microsoft's Knowledge
Base website at: http://support.microsoft.com/kb/888137.
System Device
Firmware Hub fl ash memory (System BIOS)
Local APIC
Area Reserved for the chipset
I/O APIC (4 Kbytes)
PCI Enumeration Area 1
PCI Express (256 MB)
PCI Enumeration Area 2 (if needed) -Aligned on 256-
MB boundary-
VGA Memory
TSEG
Memory available to OS and other applications
Chapter 5: Advanced Motherboard Setup
Figure 5-5. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
Possible System Memory Allocation & Availability
5-11
Front View
Note: Notch should align
with the receptive key
point on the slot.
Physical Memory
Remaining (Available)
Size
(4 GB Total System
Memory)
1 MB
3.99
4 KB
3.99
2 MB
3.99
4 KB
3.99
256 MB
3.76
256 MB
3.51
512 MB
3.01
16 MB
2.85
1 MB
2.84
2.84
Notch
Release Tab
Advertisement
Table of Contents
