Basic System Operation; Turning An Area All On; Turning An Area Part On / Part 2 On - Bosch Solution 16i User Manual

Solution16 User Guide
i
Key
Pressing any key on the keypad sounds one
Press short beep, indicating that the key press is
Tone accepted.
When you enter the premises through
a zone programmed for entry delay, the
Entry
keypad sound a Hi/Low tone to remind you
Delay to turn off the area. If the area is not turned
off before the entry delay expires, an alarm
Tone
condition will sound and a report may be
sent to your alarm company.
After you turn an area All On, the keypad will
sound 1 short beep every second. During
Exit
the last 10 seconds fast short beeps will be
Delay
heard. If you don't exit before the delay time
Tone
expires and an exit delay door is faulted, an
alarm occurs.
Error
If you press an incorrect key, your keypad
Tone will sound a 2 second tone.
The keypad will sound a Hi / Lo tone to
Menu
indicate you have entered MENU Mode and
Mode a Lo/Hi tone to indicate you have exited
MENU mode.
The keypad sounds fast short beeps to alert
Chime
you when a zone programmed for chime is
Tone
faulted or unsealled.
Table 5: Keypad Tones and Their Meanings
Figure 3: CP510i ICON Keypad
8
B a si c Sys tem O p erat i o n

Turning An Area All On

Use this function to turn the system All On. As soon as
you turn an area on, exit time will start. Exit time allows
you to exit the premises without sounding an alarm. Your
installer will program the length of exit delay time to suit
your premises.
1. Make sure that all zones are normal (not faulted).
The green indicator light will be on steady
2. Enter your PIN, then press the [ON] key.
If your PIN is valid and if all zones are normal, exit delay
time will start. You should leave now. If the control panel
detects a faulted zone, you should return it to normal, or
bypass the zone.
During exit delay, you may stop the area from turning on
by entering your PIN followed by the [OFF] key.
3. To turn the system (or area) off, enter your PIN, then
press [OFF].
The system is factory defaulted for one area. If your
i
installation has been configured for multiple areas
Note
it will be possible to arm certain areas while leaving
others disarmed.

Turning An Area Part On / Part 2 On

Use this function to turn an area Part On or Part 2 On. Part
On and Part 2 On modes can be used to turn on or arm only
part of the area, leaving the rest of the area turned off.
Your installer will program which zones are monitored for
Part On. The master user can program which zones are
monitored when an area is turned an area Part 2 On.
Once you have turned an area Part On or Part 2 On, exit
delay time starts to count down. You should leave all zones
that are active before exit delay time expires. Leaving active
zones after exit delay expires causes an alarm event.
Use Part On or Part 2 On only when you want part of an
area turned on.
1. Make sure that all zones are normal (not faulted).
2. Enter your PIN, then press the [PART] key once to
arm in Part mode 1.
3. To arm in Part On 2, press the [PART] key again
within 5 seconds.
If your PIN is valid and all zones are normal, the system
will arm in Part On mode and the Exit delay time will start.
If your system has a faulted zone, you should return it to
normal, or bypass the faulted zone.
During exit delay, you may stop the system from turning
Part On by entering your PIN followed by the [OFF] key.
Bosch Security Systems 10/07 BLCC500U FTR1.01