Program Upload; Resetting Factory Defaults; Resetting Calibration Defaults; Setting The - Chauvet Well Quad-M User Manual

Program Upload

Resetting Factory
Defaults
Resetting Calibration
Defaults

Setting the

White Color

WELL™ Quad-M User Manual
This option allows you to duplicate the custom programs of a product onto another
product using the Master/Slave mode.
1. Configure and connect the products in a Master/Slave arrangement, where the
master product has the custom programs you want to transfer to the slave products.
2. From the master product, go to the SET main level.
3. Select UPLD.
4. When PASS shows, press <ENTER>.
5. Enter the master access password (see
6. When SEND shows, press <ENTER> to start the upload.
7. Wait for the upload process to finish (the display will show OK before continuing or
turning the products off.
The Master/Slave products will provide the status of the process by lighting up as
follows:
· Yellow indicates that the upload process is running.
· Green indicates that the upload process completed successfully.
· Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact CHAUVET®
Technical Support.
Do not upload the data from a WELL™ Quad-M to a different product, as the other
product may become inoperative.
This setting allows you to reset the product's default values, including the custom
programs.
1. Go to the SET main level.
2. Select REST.
3. When PASS shows, press <ENTER>.
4. Enter the master access password (see
5. Wait for the reset process to finish.
This setting allows you to reset the product's default values of the color macros in
Setting or Whites Calibration.
1. Go to the CAL main level.
2. When PASS shows, press <ENTER>.
3. Enter the master access password.
4. Go to CALR.
5. When PASS shows, press <ENTER>.
6. Enter the master access password.
This setting allows you to select and edit the temperature of the white colors used in
channel 6 when in the TOUR mode or channel 11 when in TR16 mode.
1. Go to the CAL main level.
2. Enter the master access password as described in
3. Go to CAL1.
4. Select a white color (WH.01~11).
5. Select a color (RED, GREN, BLUE, or AMBR).
6. Select a color value (000~255).
7. Repeat for the other colors.
Control Panel Lock).
Control Panel Lock).
Control Panel Lock.
Operation
Whites
-17-