Operation
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
Automatic Programs
To run the EVE P-150 UV in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select an automatic program, from P 1–3.
4.
Press <ENTER>.
Auto-Program Speed
To change the auto-program speed on the EVE P-150 UV, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the program speed, from S 1–100.
3.
Press <ENTER>. The product will return to Auto mode.
Sound-Active Mode
To run the EVE P-150 UV in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a sound-active program, from Snd1–2.
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
Sound Sensitivity
To set the sound sensitivity on the EVE P-150 UV:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the program speed, from u 0–100.
3.
Press <ENTER>. The product will return to Sound-Active mode.
Static Mode
To run the EVE P-150 UV in static mode, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to increase or decrease the output, from d 0–255.
4.
Press <ENTER>.
Dimmer Speed Mode
To change dimmer speed on the EVE P-150 UV, follow the instructions below.
1.
Press <MENU> repeatedly until dIM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select:
•
dIM1 (fast)
•
dIM2 (medium)
•
dIM3 (slow)
or
•
OFF.
4.
Press <ENTER>.
Temperature
To view the current temperature of the EVE P-150 UV in °C, do the following:
1.
Press <MENU> repeatedly until teMP shows on the display.
2.
Press <ENTER>.
EVE P-150 UV User Manual Rev. 1
Page 9 of 14