Safety Notes; Personal Safety; Mounting And Rigging; Power And Wiring - Chauvet Well Quad-M User Manual

Before You Begin

Safety Notes

Personal Safety

Mounting and
Rigging

Power and Wiring

Operation

Expected LED
Lifespan
-2-
Read all the following Safety Notes before working with this product. These notes
include important information about the installation, usage, and maintenance of this
product.
This product contains no user-serviceable parts. Any reference to servicing in
this user manual will only apply to properly trained CHAUVET® certified
technicians. Do not open the housing or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this
product.
· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect this product from its battery charger and turn the battery switch
off before servicing.
· Always connect this product's battery charger to a grounded circuit to avoid the risk
of electrocution.
· Do not touch this product's housing when operating because it may be hot.
· Do not submerge this product or subject it to water jets (IP44). Regular outdoor
operation under light rain or splashing water is fine.
· Do not hang this product, as this is a floor-standing product.
· Always carry this product using the built-in handle.
· Do not leave any flammable material within 50 cm of this product while operating or
recharging the battery.
· Always make sure that you are connecting this product's battery charger to the
proper voltage, as per the specifications in this manual or on the product's sticker.
· Never connect this product's battery charger to a dimmer pack or rheostat.
· Never disconnect this product's battery charger by pulling or tugging on the power
cable.
· Do not operate this product if you see damage on the housing, lenses, or cables. In
any of these cases, have the damaged parts replaced by an authorized technician
at once.
· Do not cover the ventilation slots when the product is operating to avoid internal
overheating.
· The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate this
product at a higher temperature.
· Do not close the flight case/charger lid when during charging.
· In case of a serious operating problem, stop using this product immediately!
In the unlikely event that your CHAUVET® product may require service, contact
CHAUVET® Technical Support.
LEDs gradually decline in brightness over time, mostly because of heat. Packaged in
clusters, LEDs exhibit higher operating temperatures than in ideal, single-LED
conditions. For this reason, using clustered LEDs at their fullest intensity significantly
reduces the LEDs' lifespan. Under normal conditions, this lifespan can be 40,000 to
50,000 hours. If extending this lifespan is vital, lower the operating temperature by
improving the ventilation around the product and reducing the ambient temperature to
an optimal operating range. In addition, limiting the overall projection intensity may also
help to extend the LEDs' lifespan.
WELL™ Quad-M User Manual