Table of Contents
Advertisement
Operation
Dimmer Curves
Dimmer Curve
Settings
Control Panel Lock
Password
Settings Lock Out
-16-
This setting provides you with four options to simulate the dimming curve of an
incandescent light product.
1. Go to the SET main level.
2. Select DIMX.
3. Select the desired dimmer curve (OFF, DIM1, DIM2, DIM3, or DIM4).
OFF
The output is proportional (linear) to the dimmer and RGBA channel
values.
DIM1~4:
The output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, being DIM1 the fastest and DIM4 the
slowest.
This setting allows you to select the dimmer curve shape using the red, green, blue,
amber, and dimmer faders.
1. Go to the SET main level.
2. Select CURV.
3. Select the desired dimmer curve (OFF, CV1, CV2, or CV3).
OFF
This output is proportional (linear) to the Dimmer and RGBA channel
values.
CV1~3
This output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, being CV1 the fastest and CV3 the slowest.
For optimum control of the 16-bit dimming channels in the TR16 personality, be
sure that both dimming curves in SET > DIMX and SET > CURV are set to OFF
This setting enables you to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the product's settings.
1. Go to the KEY main level.
2. Select ON or OFF.
When the control panel lock is active, the product will prompt you to enter the
password after 30 seconds of control panel inactivity or after turning on the
product.
If you are prompted to enter a password on the product, press the buttons in the
following order: UP > DOWN > UP > DOWN > ENTER. The product's password cannot
be changed and must be entered whenever you are prompted.
This setting enables you to activate or disable the main level SET (settings) lock, which
keeps unauthorized personnel from changing the product's settings.
1. Go to the SET main level.
2. Select SLCK.
3. Select ON or OFF.
WELL™ Quad-M User Manual
Advertisement
Table of Contents
