Dmx Linking; Dmx Modes; Master/Slave Connectivity - Chauvet Well Quad-M User Manual

DMX Linking

DMX Modes

Master/Slave
Connectivity
WELL™ Quad-M User Manual
You can link the WELL™ Quad-M to a DMX controller using a standard DMX serial
connection or via W-DMX™. If using other DMX compatible products with the
WELL™ Quad-M, you can control each individually with a single DMX controller.
The WELL™ Quad-M uses the standard DMX data connection for its TOUR, TR16,
ARC.1, AR1.D, ARC.2, AR2.D, AR2.S and HSV DMX modes.
· Refer to the
Introduction
· Refer to the
Operation
in these modes.
· The
DMX Values section provides you with detailed information regarding the DMX
modes.
The Master/Slave mode allows a WELL™ Quad-M (master product) to control one or
more products (slave products) without a DMX controller.
One WELL™ Quad-M becomes the master product either when running in static (STAT)
mode or when using the automatic (AT) or customizable (PR) programs.
In addition, you must configure each of the slave products (via control panel) to operate
in Slave (SLAV) mode. During Master/Slave operation, the slave products will operate in
unison with the master product.
For more information, see the
Do not connect a DMX controller to products operating in Master/Slave mode. The
DMX controller signals may interfere with the signals from the master product.
· The
Operation section of this manual provides detailed instructions on how to
configure the Master and Slave products.
· If you need more information about DMX standards, Master/Slave connectivity,
or the DMX cables needed in order to link the product to a DMX controller, you
can download the DMX Primer from the CHAUVET® website:
www.chauvetpro.com.
· Verify the DIMX and CURV settings are set to OFF for optimal control of the
TR16 personality. For more information, see the
section for a brief description of these modes.
section to learn how to configure the WELL™ Quad-M to work
Menu Map section.
Menu Map section.
Setup
-9-