Control Code Selection - TEC B-450 SERIES User Manual

6. DIAG. TEST OPERATION

6.3.10 Control Code Selection

Press the [C] key.
NOTES: 1. Holding the [ ↓ ] key or [ ↑ ] key down for more than 0.5 seconds enables a fast forward.
2. A changed control code is stored in keyboard memory by pressing the [ → ] key.
Power off
Turn on the power while
holding down the [SHIFT]
key.
< 1 >
D I A G .
Press the [↓] key.
< 2 >
P A R A M E T E R
Press the [→] key ten times.
C O D E A U T O
Select control code with the
[↓] key or [↑]
key. (See NOTE 1.)
Press the [ENTER] key.
S E T O P R I N
T
Y E S : [ E N T ]
Press the [ENTER] key or [C] key.
S E T
• AUTO: (Automatic selection)
• ESC, LF, NUL: (Manual selection)
• { , , } : (Manual selection)
Press the [→] key.
T E R ?
Continued on Section 6.3.11
N O : [ C ] Ribbon Take-up motor
Voltage Fine Adjustment
6-27
EO18-33003A
6.3 PARAMETER SETTING MODE