Electronics Specifications - TEC B-450 SERIES User Manual

1. OUTLINE OF THE SYSTEM

1.5 ELECTRONICS SPECIFICATIONS

1) CPU ............................... V55PI (16 MHz), 120 Pin QFP (0.5 mm)
2) Memory
1 Program:
2 Backup:
Image buffer + Work: [TS model] D-RAM 2 MB (Image buffer 1792 KB, Work 256 KB)
3
NOTE: The 1 MB Flash ROM can be used for the QQ models manufactured before August "99
(Serial No. 9Nxxxxxx or earlier).
3) Interface
RS-232C interface
1
(1)Communication mode:
(2)Transmission speed:
(3)Synchronization:
(4)Transmission parameter
Parity:
Start bit:
Stop bit:
Word length
(5)Error detection
Parity check: VRC (Vartical parity check)
Framing error: This error occurs when no stop bit is found in the frame specified startig
Overrun error: This error occurs when subsequent data is input before the data input to
(6)Data entry code: ASCII, 8-bit code for European characters, 8-bit code for graphic
(7)Receiving buffer: 5 KB
(8)Protcol
XON/XOFF (DC1/DC3) protocol
• When initialized after power on, this printer becomes ready to receive data and sends
an XON code (11H). (Trasmission or non-transmission of XON code is selectable by
means of the DIP switch.)
• The printer sends an XOFF code (13H) when the blank positions in the receive buffer
becomes 800 Bytes or less.
• The printer sends an XON code (11H) when the blank positions in the receive buffer
are 2KB or more.
• When there are no blank positions in the receive buffer, the printer discards data
received which exceeds the receive buffer capacity, without storing it in the buffer.
(After detecting the XOFF code, the host computer must stop transmission before the
printer receive buffer becomes full.)
• The ptinter sends an XOFF code (13H) at power off time. (XOFF code send is selectable with
Dip switch.)
Flash ROM 2 MB
EE-PROM 128 Bytes
[HS model] D-RAM 4 MB (Image buffer 3840 KB, Work 256 KB)
Full-duplex
2400,4800,9600,19200 BPS (selectable)
start-stop synchronization
None, EVEN
1-bit
1-bit
8-bit
with the start bit.
the UART from the host is read by the printer.
1-6
EO10-33003A
1.5 ELECTRONICS SPECIFICATIONS