Control Code Selection - TEC B-672 Maintenance Manual

6. DIAG. TEST OPERATION
6.3.8
< 1
< 2
C O
When {MANUAL} is
selected, go to A
on the next page.
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es

Control Code Selection

Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
>
D I A G N O S T I C
Press the [FEED] key.
>
P A R A M E T E R
Press the [PAUSE] key nine times.
D E
Select control code with the
[FEED] key or [RESTART]
key. (See NOTE 1.)
B
Press the [FEED] key
and [RESTART] key
at the same time.
a fast forward.
2. A changed control code is stored in memory by pressing the [PAUSE] key.
3. When "AUTO", "ESC, LF, NUL", or "{, ,}" is selected, be sure to select the Non-
transmissive ribbon in the ribbon type selection operation.
4. When "MANUAL" is selected, be sure to specify all the control codes 1 to 3. Failure
to do this disables selection of "MANUAL".
V 1 . O A
S E T
A U T O
• AUTO: (Automatic selection)
• ESC, LF, NUL: (Manual selection)
• { , , } : (Manual selection)
• MANUAL: (control codes should be specified.)
Press the [PAUSE] key.
Continued on Section 6.3.9
Ribbon type selection.
6-27
EM18-33017
SVO8A1002 : Jan. 19, '98
6.3 PARAMETER SETTING MODE