Parity Selection; Transmission Control Code Selection - TEC SX4T - B B/W Direct Thermal User Manual

5. SYSTEM MODE

5.4.6 Parity Selection

With this parameter you can select the parity of the RS-232C interface.
When "<2>PARAMETER SET" appears, press the [PAUSE] key and the [FEED] key 5 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the parity, press the [PAUSE] key.

5.4.7 Transmission Control Code Selection

With this parameter you can select the transmission control code of the RS-232C interface.
When "<2>PARAMETER SET" appears, press the [PAUSE] key and the [FEED] key 6 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the transmission control code, press the [PAUSE] key.
NOTE: The following is the detailed descriptions for each transmission control code.
1) XON/XOFF AUTO
At the power on time, the printer outputs XON. At the power off time, the printer outputs
XOFF.
2) XON+READY AUTO
At the power on time, the printer outputs XON. At the power off time, the printer outputs
XOFF.
3) READY/BUSY
At the power on time, the DTR signal output from the printer turns to High level
(READY). At the power off time, the printer does not output XOFF.
4) XON/XOFF
At the power on time, the printer outputs XON. At the power off time, the printer does
not output XOFF.
5) READY/BUSY RTS
At the power on time, the RTS signal output from the printer turns to High level
(READY). At the power off time, the printer does not output XOFF.
XON/XOFF mode
XON/XOFF+READY/BUSY (DTR) mode
READY/BUSY (DTR) mode
XON/XOFF mode
RTS mode
5-22
EO18-33012A
5.4 PARAMETER SETTING