5
Carefully wipe the scanning glass with a soft, dry cloth.
•
If the glass is very dirty, first wipe it with a slightly dampened cloth, then with a
dry one.
•
Be careful not to scratch the glass surface.
6
Replace the roller in reverse order, and then close the front panel firmly until it clicks
into place.
adjust the scanner
The scanner is adjusted at the factory. If, however, you drop your machine while moving it,
we recommend you adjust scanner.
1
Press Menu repeatedly until MAINTENANCE appears and press Start/Enter.
2
Scroll to Adjust Scanner by pressing
3
Load a plain WHITE sheet of paper (no writing or graphics) into the document feeder
and press Start/Enter.
•
The machine starts to scan the document to adjust the scanner.
•
Printing quality may be unexpectedly worse if you do not use a plain WHITE
paper for the adjustment.
LCD error messages
These are the error message that may display along with solutions.
Display
Adjust scanner first
in Maintenance menu
Check white paper
document and try
again
Clean white roller,
glass and try again
Duplicated with
[Speed No.xx]
adjust the scanner
and press Start/Enter.
Status/Solution
Adjust the scanner to fix this problem as described in adjust the
scanner on page 39.
You must use plain, white paper when adjusting the scanner. See
adjust the scanner on page 39.
For more information, see clean the document scanner area on
page 38.
The same number has already been registered into another speed dial
code.
hp fax 1010 series
39