Detaching The Monitor Panel; Attaching The Monitor Panel - Kenwood DNX9280BT Instruction Manual

Basic Operation
Removing the SD card
Push the SD card until it clicks and then remove
your finger from the card. The card pops up so
that you can pull it out with your fingers.
Press the [0] button for longer than 1 second to
close the front panel.
⁄
• The playback starts automatically after loading the
media or connecting the device.

Detaching the monitor panel

1 Open the front panel
0
3 sec.
Press the [0] button for longer than 3 seconds to
open the front panel before turning the ignition
off.
⁄
• You can set the front panel to open automatically
when the ignition is turned off. Refer to
Angle Control> (page
2 Detach the monitor panel
1
16
DNX9280BT
<Monitor
73).
3
2
4
⁄
• The attaching plate closes automatically about 10
seconds after the monitor panel is released. Remove
the monitor panel before this happens.
3 Put the monitor panel in the protective bag

Attaching the monitor panel

Hold the monitor panel securely so as not to
drop it accidentally.
Fit the monitor panel onto the attaching plate
until it is firmly locked.
1
1
2
3