Help? Error - Kenwood DNX9280BT Instruction Manual

Help?
Error
When the unit fails to operate correctly, the
cause of the failure appears on the display.
"Protect" :
Protective circuit has been activated because a speaker
cord has shorted or it has come in contact with the car
chassis.
➡ Wire or insulate the speaker cord as appropriate and
then push the Reset button.
"Hot Error" :
When the internal temperature of this unit rises to 60°C
or more, the protection circuit is activated and you
may not be able to operate the unit. At such times this
message will appear.
➡ Use the unit again after reducing the temperature
inside the vehicle.
"Mecha Error" :
The disc player is malfunctioning.
➡ Eject the disc and try inserting it again. Contact the
Kenwood dealer if this indicator continues blinking or
the disc cannot be ejected.
"Disc Error" :
An unplayable disc is inserted.
"Read Error" :
Disc is quite dirty.
➡ Clean the disc, referring tot he section on
discs> (page 4).
Disc is upside down.
➡ Load the disc with the labeled side up.
"Region code Error" :
The disc you wanted to play has a region code that
cannot be played with this unit.
"Parental level Error" :
The disc you wanted to play has a higher level than the
parental level you set.
"Error 07–67" :
The unit is not operating correctly due to some reason
or other.
➡ Push the unit's Reset button. If the "Error 07−67"
message does not disappear, see your nearest
Kenwood dealer.
"No Device" (USB device):
The USB device is selected as a source although no USB
device is connected.
➡ Change the source to any source other than USB/
iPod. Connect an USB device, and change the source
to USB again.
94
DNX9280BT
"Disconnected" (iPod, Bluetooth audio player):
The iPod/Bluetooth audio player is selected as a source
although no iPod/Bluetooth audio player is connected.
➡ Change the source to any source other than iPod/
Bluetooth. Connect an iPod/Bluetooth audio player,
and change the source to iPod/Bluetooth again.
"No Music" :
The connected USB device contains no playable audio
file.
Media was played that doesn't have data recorded that
the unit can play.
"USB Device Error!!" :
The connected USB device is rated a current capacity
higher than the allowable limit.
➡ Check the USB device.
Some trouble may have occurred to the connected USB
device.
➡ Change the source to any source other than USB.
Remove the USB device.
"Authorization Error" :
Connection to the iPod has failed.
➡ Remove the iPod and then reconnect it.
The unit does not support the iPod.
➡ Refer to
unit> (page
"Update your iPod" :
<Handling
The iPod's software is an older version which the unit
can not support.
➡ Confirm that the software for the iPod is the latest
version. Refer to
to this unit> (page
"Update your USB database" :
The USB device is different from the previous one or the
contained audio files are replaced.
➡ Update your database. Refer to
Screen> (page 26)
"Navigation Error. Please turn on power again later."
:
The communication error has occurred due to severely
cold temperature.
➡ Turn on power again after warming your car interior.
<iPod/iPhone that can be connected to this
7).
<iPod/iPhone that can be connected
7).
<Source Control
of USB Device Control.