Speaker Setup; [Audio Setup]; [Speaker Select] - Kenwood DNX9280BT Instruction Manual

Speaker Setup

You can select a speaker type and its size to get the
best sound effects.
1 Display the Speaker Select screen
>
Touch [ ] [
[Speaker Select]. (page 60)
2 Select a speaker you wish to adjust
When the speaker type and size are set, the
speaker crossover network and equalizer curve are
set automatically.
1
2
3
4
1 Center speaker
2 Front speaker
3 Rear speaker
4 Subwoofer
[Tweeter] You can set the tweeter when you are
selecting front speakers.
If you are using a tweeter together with the front
speakers, set the tweeter to "ON". In the "ON"
position, the Equalizer is adjusted to its best
position.
[X'over] Displays the Speaker Crossover Setup
screen.
You can adjust the crossover setup that was set
automatically when you selected the speaker
type.
3 Select a speaker type
You can select any of the following speaker types.
"Center" None, 40x70 mm, 5 cm, 10 cm, 13 cm,
16 cm over
"Front" OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18 cm,
4x6, 5x7, 6x8, 6x9, 7x10
"Rear" None, OEM, 10 cm, 13 cm, 16 cm, 17 cm,
18 cm, 4x6, 5x7, 6x8, 6x9, 7x10
"Subwoofer" None, 16 cm, 20 cm, 25 cm, 30 cm,
38 cm over
> >
]

[Audio SETUP]

⁄
• Select "None" if you have no speakers.
• If you set the center speaker to "None" even in a short
time when you are setting the Surround Control to
"Bypass+Center", the Surround Control is set to "Bypass"
automatically. See <Surround Control> (page
• If you set the center and rear speakers to "None" when
you are setting the Surround Control to "Dolby PL II",
the Surround Control is set to "Bypass" automatically.
See <Surround Control> (page
Crossover Network Setup
You can set a crossover frequency of speakers.
1 Select the speaker to set the crossover
1
2
3
4
1 Sets the High Pass Filter of the center speaker.
2 Sets the High Pass Filter of the front speaker.
3 Sets the High Pass Filter of the rear speaker.
4 Sets the Low Pass Filter of the subwoofer.
2 Display the Crossover setup screen
3 Set the crossover
[Phase] Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set to
"Reverse". (Only when "Subwoofer" is set to any
item other than "None" in Speaker Setup)
[HPF FREQ] High Pass Filter adjustment. (When
front, center or rear speaker is selected on
Speaker Select screen)
[LPF FREQ] Low Pass Filter adjustment. (When
Subwoofer is selected on Speaker Select screen)
[Slope] Sets a crossover slope.
64).
64).
Next page 3
65
English