Call Forwarding Unconditional - Siemens HiPath 8000 Operating Manual

Step by Step

Call forwarding unconditional

With Call forwarding unconditional, all incoming calls
are forwarded to a different destination.
You can use the feature code to activate/deactivate this
function and define a forwarding destination.
Activating
^
Lift the handset.
j
Enter the code, for example, *72 (contact your service
personnel).
Z
Wait until you hear the confirmation tone.
j
Enter the number of the phone to which you want to
forward the calls.
Z
Wait until you hear the confirmation tone.
If the "Courtesy call" function is active, the System dials
the phone to which you forwarded your calls.
• If the party at this phone answers, you can inform
him or her that your calls are being forwarded.
• If the party does not answer or the station is busy,
activate the feature once again. If you complete this
operation within two minutes, you will hear the con-
firmation tone followed by the dial tone. The System
does not output an acoustic signal to inform the oth-
er party at the forwarding destination about the sec-
ond activation.
If Call forwarding unconditional is active, calls for-
warded when the line is idle are signaled by a short ring
burst (around 0.5 seconds) at the forwarded station.
This is a reminder that this feature is active.
Deactivating
^
Lift the handset.
j
Enter the code, for example, *73 (contact your service
personnel).
HiPath 8000 functions
131