Starting Up The Controller And Logging In And Out - Extron electronics FPC 5000 User Manual

Matrix 12800 Operation, cont'd

Starting Up the Controller and Logging In and Out

Use the FPC to control the matrix as follows:
1.
2.
Figure 3-4 — Startup screen
3.
Figure 3-5 — Address and password entry
4.
3-4 FPC 5000 Front Panel Controller • Matrix 12800 Operation
Ensure that all BMEs that are part of the system have been connected to each
other and their BME numbers have been set correctly (refer to the Matrix
12800 Wideband, Sync, or Audio Switchers User's Manual, part #68-556-01).
If necessary, on the rear of the FPC, toggle the Power switch to the on ( )
position. After approximately 2 minutes, the LCD touch panel displays the
FPC startup screen (figure 3-4). Observe the message **NOT Logged On** in
the upper right corner of the blue field.
The FPC 5000 LCD has an optional screen saver function that blanks the
screen after 5 minutes. Touch on the screen to wake up the controller. See
Miscellaneous screen, in this chapter, to disable the screen saver.
Touch the Log On button.
Decide whether you need to edit the FPC 5000's IP Address and Subnet Mask
fields (see the guidelines below). If you need to edit the fields, proceed to
step 5. If you do not need to need to edit the fields, proceed to step 6.
The IP Connection screen appears (figure 3-5).