Installing And Starting The Control; Installing The Program - Extron electronics CrossPoint 450 Plus Series Setup Manual

Installing and Starting the Control Program
You can also operate the switcher via the Windows
Switchers Control Program. This program is available on the Extron
website, www.extron.com. Run this program on a PC connected
to either of the switcher's serial ports or the Ethernet port. See
i
on page 7 and
NOTE:
CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus Switcher
User Guide, chapter 5, "Matrix Software".

Installing the program

1. Go to
Download
appears (
2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3
2. Click the
3. Click the M filtering letter (
downloads nearest the program.
4.
Click
5.
Follow the on-screen instructions. The installation program
creates a
directory and an "Extron Electronics\Matrix Switchers" group
folder. It installs the following four programs:
• MATRIX Switcher+ Control Program
• MATRIX Switcher+ Help
• Uninstall MATRIX Switcher
• Check for Matrix Updates
a
on page 8, for connection information.
For details on operating the program, refer to the
www.extron.com
1
tab ( ). The Find Software & Downloads
2
).
3
( ) link. The main download page opens.
Software
for the Matrix Switchers Control Program (
Download
C: \ Program Files
CrossPoint / MAV Matrix Switchers • Remote Control
and hover the cursor over the
) to jump to the page of
\ Extron \ Matrix _
-based Matrix
®
h
,
link
1 1 1 1 1 1 1 1 1 1
4
).
1 1 1 1 1 1 1 1 1 1
Switchers
21