Installing And Starting The Control Program; Installing The Program; First-Time Connection Considerations - Extron electronics MTPX Plus Series Setup Manual

Installing and Starting the Control Program

Another way to operate the switcher, to set the skew adjustments, the level and peaking,
and the output pre-peaking (see
Windows®-based Matrix Switchers Control Program.
Run this program on a PC connected to a serial port (see
Ethernet port (see
The program must be installed on a Windows-based computer.
NOTE:

Installing the Program

1.
2.
3.
4.

First-time Connection Considerations

LAN port connection
If you connect your PC to the switcher via the LAN port, and it is the first time you have
done so, you may change the default settings (IP address, subnet mask, and [optional]
administrator name and password) on the controller (see
Communication
NOTE: The factory configured passwords for all accounts on this device have been set
on page 8), or USB port (see
£
For details on operating the program, refer to the MTPX Plus User Guide.
On the Extron website, click Download > Software.
Click the letter M button.
Scroll to Matrix Switchers and click Download.
Extron recommends that you read the Release Notes located in the first
NOTE:
column.
Follow the on-screen instructions.
NOTE: If your download does not automatically start, select the click here link
that is beneath Download Center.
The installation program creates a
C:\Program Files (x86)\Extron\Matrix_Switchers directory.
on page 29).
to the device serial number. Passwords are case sensitive.
If the device is reset, the password will be the original password configuration, which is
no password.
MTPX Plus Series Setup Guide • Remote Control and Optimizing the Video
Optimizing the video on page 25), is via the
9
on page 8) on the switcher.
¦
Configuring for Network
, , and on page 8),
¢ ¥
23