Installing And Starting The Control Programs; Installing The Programs - Extron electronics DTP CrossPoint 84 Setup Manual

Installing and Starting the Control Programs

Several useful Windows-based programs are available on the Extron
website, including the Digital Signal Processor (DSP) Configurator program,
the Product Configuration Software (PCS), and the Firmware Loader
program.
The Product Configuration Software configures the video functions of the
switcher.
The DSP Configurator program is required for full operation of the
DSP functions of the switchers and to save presets. It also provides
some limited control of the non-DSP functions of the switcher. See
the DTP Crosspoint 84 User Guide and the program Help file for more
information.
Run either program from a PC connected to an
item
R
NOTES:
•
•

Installing the programs

The DSP Configurator, version 2.6 or newer; PCS, version 2.0 or newer;
and Firmware Loader are available on the Extron website. Download and
install all programs as follows:
NOTE:
Explorer
indications may be different.
1.
Go to
(see figure 11,
(
2
2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3
Figure 11.
26 DTP CrossPoint 84 • Remote Control
on page 8) or USB port (item
For details on operating the program, see the DTP CrossPoint 84
Switcher User Guide.
The DSP Configurator program has a software switch that allows
you to lock out audio adjustments in the Product Configuration
Software, making them unavailable for selection.
This procedure was written using Microsoft
. Depending on the browser you use, some steps or
®
www.extron.com
Find Software & Downloads
). The
1
).
Find Software and Downloads
(item
on page 14) on the switcher.
A
and hover the cursor over the Download tab
on page 7 or
Q
Internet
®
link appears
1 1 1 1 1 1 1 1 1 1