Furniture Mounting; Projector Mounting; Pmk 100 Mini Projector Mounting Kit - Extron electronics VersaTools MDA 2V EQ User Manual

Versatools video mini distribution amplifiers
Hide thumbs Also See for VersaTools MDA 2V EQ:
Table of Contents

Advertisement

Installation and Operation, cont'd
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Mounting an MDA EQ on a 6-inch rack shelf

Furniture mounting

To furniture-mount the MDA EQ, use the optional MBU 123
mini under-desk mounting kit (part #70-212-01), as follows.
Preparing the MDA EQ for under-desk mounting
If rubber feet were previously attached to the bottom of the
1.
unit, remove them.
2
Attach the mounting brackets to the MDA EQ with the
provided machine screws as shown in the previous figure.
VersaTools
®
MDA EQ Series • Installation and Operation
2-4
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
3.
Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket's screw holes.
Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
4.
in the mounting surface at the marked screw locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
6.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7.
Slide the unit slightly forward or back, then tighten all
four screws to secure it in place.

Projector mounting

To projector-mount the MDA EQ, use one of the optional
mounting kits described in the following sections.

PMK 100 Mini Projector Mounting Kit

The PMK 100 is a projector mounting kit (part #70-217-01)
designed for use with Extron 1U high, quarter-rack width
products like the VersaTools products. It allows them to be
mounted near or on a projector support.
Mounting
Bolt
Projector
Mounting
Bracket
Projector
Projector-mounting the MDA EQ using the
PMK 100 Projector Mounting Kit
Follow these steps to projector-mount the MDA EQ using the
PMK 100 kit:
1.
If rubber feet are attached to the bottom of the MDA EQ,
remove them.
VersaTools
®
MDA EQ Series • Installation and Operation
2-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Versatools mda 4v eqVersatools mda 4sv eq

Table of Contents