Mounting The Mda Eq Series; Tabletop Use; Rack Mounting - Extron electronics VersaTools MDA 2V EQ User Manual

Installation and Operation

Mounting the MDA EQ Series

The MDA EQ mini distribution amplifiers can be set on a table;
mounted on a rack shelf; attached to a projector; or mounted
under a desk, podium, or tabletop.
The following kits are available for mounting the MDA EQ:
•
RSB 123 1U, 3.5" deep basic VersaTools rack shelf (part
#60-604-20)
•
RSF 123 1U, 3.5" deep VersaTools rack shelf kit (part
#60-190-20)
•
RSB 126 1U, 6" deep basic rack shelf (part #60-604-10)
•
RSU 126 1U, 6" deep universal rack shelf kit (part
#60-190-10)
•
RSB 129 1U, 9.5" deep basic rack shelf (part #60-604-01)
•
RSU 129 1U, 9.5" deep universal rack shelf kit (part
#60-190-01)
•
MBU 123 mini under-desk mounting bracket kit (part
#70-212-01)
•
VersaTools projector mounting kits: PMK 100 (part
#70-367-01), PMK 300 (part #70-374-01), or PMK 350 (part
#70-563-02 or 70-563-03).

Tabletop use

Four self-adhesive rubber feet are included with the MDA EQ.
For tabletop use, attach one foot at each corner of the bottom
side of the unit and place the unit in the desired location.

Rack mounting

For optional rack mounting, mount the MDA EQ on one of the
rack shelves or projector mounting brackets listed above. On
the standard 9.5" deep rack shelves, the unit can be mounted in
one of four locations to the rear of the rack or in one of four
locations to the front of the rack.
N
Only products in the VersaTools and IP Link lines can be
mounted on a VersaTools shelf. Any 1U rack-mountable
Extron product can be mounted on the standard shelf.
1. If rubber feet are installed on the bottom of the MDA,
remove them.
®
2-2 VersaTools MDA EQ Series • Installation and Operation
2. Mount the MDA EQ on the rack shelf, using two
4-40 x 3/16" screws in opposite (diagonal) corners to
secure the unit to the shelf.
Install blank panel(s) or other unit(s) on the rack shelf.
3.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Use 2 mounting holes on
opposite corners.
Mounting MDAs on a VersaTools rack shelf
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
Both front false faceplates
use 2 screws.
Use 2 mounting holes on
opposite corners.
Mounting an MDA EQ on a standard rack shelf
®
VersaTools MDA EQ Series • Installation and Operation
(2) 4-40 x 3/16"
Screws
1/4 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
2-3