Summary of Contents for Extron electronics VersaTools MDA 5V
Page 1
User’s Guide VersaTools™ MDA 5V, 5SV, 5A RCA Mini Distribution Amplifiers 68-614-01 Rev. C 07 08...
Page 2
Precautions Safety Instructions • English Warning Power sources • This equipment should be operated only from the power source This symbol is intended to alert the user of important indicated on the product. This equipment is intended to be used with a main power operating and maintenance (servicing) instructions in system with a grounded (neutral) conductor.
Introduction Introduction The Extron MDA 5 Series of Mini Distribution Amplifiers (MDAs) are a family of three video and audio distribution amplifiers. The MDA are members of the Extron VersaTools line ™ of basic distribution amplifiers, switchers, and associated video accessories.
grounding of rack-mounted equipment. Pay particular attention to supply connections other than direct connections to the branch circuit (such as the use of power strips). Rack mounting procedures For optional rack mounting, mount the MDA on a VersaTools 3.5" deep 1U Rack Shelf (Extron part #60-190-20) (figure 1) or a standard Universal 1U 9.5"...
Installation Only products in the VersaTools line can be mounted to a VersaTools shelf. Any 1U rack-mountable Extron product can be mounted on the standard shelf. Figure 2 — Mounting the MDA on the standard shelf Furniture or projector mounting Furniture mount or projector mount the MDA using the optional mounting kit (Part #70-212-01, furniture, or 70-217-01, projector) as follows:...
Page 7
If feet were previously installed on the bottom of the MDA, remove them. For furniture mounting, hold the MDA with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.
Page 8
Connections POWER Ridges Smooth Power Receptacle 0.4A MAX SECTION A–A Power Supply Output Cord DC Power Cord Captive Screw Connector Negative +12 VDC External Power Supply (12 VDC, 1 A ) AC Power Cord Figure 4 — Power connector wiring When connecting the power supply, voltage polarity is extremely important.
Front Panel All Models DISTRIBUTION AMPLIFIER INPUT OUTPUTS MDA 5V Rear Panel POWER HIGH Z MDA 5V .5A MAX 75 Ohm LOOP INPUT OUTPUTS MDA 5SV Rear Panel POWER HIGH Z MDA 5SV .5A MAX 75 Ohm LOOP MDA 5A RCA Rear Panel POWER MDA 5A RCA...
Specifications Specifications Video Gain ..........Unity Bandwidth Composite video ....400 MHz (-3dB) S-video ........ 270 MHz (-3dB) Video input Number/signal type MDA 5SV......1 S-video MDA 5V......1 composite video Connectors MDA 5SV......1 4-pin mini DIN female MDA 5V......1 BNC female Nominal level ........
Page 11
DC offset ........±50 mV with input at 0 offset Sync Standards........NTSC 3.58, NTSC 4.43, PAL, SECAM Audio — MDA 5A RCA Gain DIP switch set to match output type ..... Unity (0dB) DIP switch not matched to output type Dip Switch Output Wiring Setting...
Page 12
Specifications Power input requirements MDA 5V/5SV ....12 VDC, 0.1 A (max.) MDA 5A RCA ....12 VDC, 0.2 A (max.) Temperature/humidity ....Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing Cooling ...........
Page 15
In no event will Extron Electronics be liable for direct, indirect, or consequential damages resulting from any defect in this product even if Extron Electronics has been advised of such damage.
Need help?
Do you have a question about the VersaTools MDA 5V and is the answer not in the manual?
Questions and answers