Under-Furniture Mounting; Through-Furniture Mounting - Extron electronics P/2 DA2xi User Manual

Installation and Operation, cont'd
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Use 2 mounting holes on
opposite corners.
Mounting the P/2 DA2xi on a VersaTools rack shelf

Under-furniture mounting

The P/2 DA2xi can be mounted under a table or other
horizontal surface using an optional Extron MBU 125 under-
desk mounting kit (part #70-077-01). Mount the unit under a
desk or table, as follows:
Under-desk mounting
4 P/2 DA2xi • Installation and Operation
(2) 4-40 x 3/16"
Screws
1. Secure the under-desk mounting brackets to the
distribution amplifi er with the four machine screws
provided in the mounting kit.
2. Hold the unit with attached brackets against the underside
of the desk or other furniture. Mark the location of holes
for screws on the desk.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside or inside (the concealed side) of the
furniture, where the distribution amplifi er will be located.
Insert the four wood screws into the pilot holes. Fasten
4.
each screw into the installation surface until just less than
1/4" of the screw head protrudes.
5. Align the installed screws with the slots in the mounting
brackets, and place the unit against the surface, with the
screws through the bracket slots.
6. Slide the unit slightly forward or back, then tighten all four
screws to fasten it in place.

Through-furniture mounting

The distribution amplifi er can be mounted through a desk or
other furniture using an optional Extron MBD 129 through-desk
mounting kit, part #70-077-02. Mount the P/2 DA2xi through a
desk or table, as follows:
Through-desk mounting
P/2 DA2xi • Installation and Operation 5