Furniture Mounting - Under-Desk - Extron electronics CVEQ 100 User Manual
1-input, 1-output equalizing composite video and s-video line drivers
Hide thumbs
Also See for CVEQ 100:
- Specifications (4 pages) ,
- Specification (4 pages) ,
- Brochure & specs (3 pages)
Table of Contents
Advertisement
QuarterRackStandardShelf
im Vertrieb von
Installation and Operation, cont'd
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
Use 2 mounting holes on
opposite corners.
Mounting the line driver on a standard rack shelf
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Mounting the line driver on a 6-inch rack shelf
www.camboard.de
2-4
CVEQ 100 & SVEQ 100 • Installation and Operation
CAMBOARD Electronics
1/2 Rack Width Front False
Faceplate
1/4 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
Tel. 07131 911201
Fax 07131 911203
QuarterRackUnderdeskMounting
Furniture mounting — under-desk
To mount the line driver under furniture, use the optional
®
VersaTools
under-desk mounting kit for the SVEQ 100
(Extron MBU 123, part #70-212-01) or the optional under-desk
kit for the CVEQ 100 (Extron MBU 125, part #70-077-01).
Under-desk mounting kit
part # 70-212-01
Preparing the line driver for under-desk mounting
1.
If rubber feet were previously attached to the bottom of the
unit, remove them.
2.
Attach the mounting brackets to the line driver with the
provided machine screws as shown in the previous figure.
3.
Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket's screw holes.
4.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
6.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7.
Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
ce-info@camboard.de
CVEQ 100 & SVEQ 100 • Installation and Operation
Under-desk mounting kit
part # 70-077-01
2-5
Advertisement
Table of Contents
