Table of Contents
Advertisement
Installation and Operation, cont'd
2.
Attach the projector mounting bracket to the side of the
MDA EQ, using the provided machine screws.
3.
Secure the unit to a projector mount or other surface by
inserting the mounting bolt through the bracket's slotted
hole.
See the illustration on the previous page.
PMK 300 Projector Mounting Kit
The PMK 300 Multi-Product Projector Mounting Kit
(#70-374-01) mounts up to three quarter-rack width products to
a projector ceiling mount pole. The MDA EQ can be mounted
above the display device with the front panel facing either
down or up. The quarter rack width plate can also be used to
mount the MDA external desktop power supply.
Countoured
Bracket
Base
U-bolt
Projector-mounting the MDA EQ using the
PMK 300 Projector Mounting Kit
Follow these steps to mount the MDA EQ using the PMK 300:
1.
If necessary, remove the feet from the bottom of the MDA.
2.
Mount the MDA to one of the bracket's three mounting
plates, using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down. See the illustration, above.
2-6
VersaTools
®
MDA EQ Series • Installation and Operation
Side Mounting
Plate
Extron
MDA EQ Series
Mini Distribution Amplifier
Power Supply
Extron
PMK 300
Multi-product Projector Mount Kit
Front Mounting
Plate
•
On the side mounting plates, the MDA is typically
mounted on the outside of the bracket.
•
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
3.
Using the two included tie wraps, strap the power supply
to one of the brackets.
4.
Place the contoured bracket base against the projector
ceiling pole and opposite the back plate. The pole should
fit snugly into the depression in the center of the
contoured base.
N
The PMK 300 has a hole in the bottom plate that allows
the projector pole to be inserted through the center of the
plate, rather than outside of the plate (see the illustration
on the next page). To install the PMK 300 in this
configuration, slide the bracket up from the bottom of the
pole before the projector is installed on the pole.
Contoured
Bracket
Base
U-bolt
Mounting the MDA EQ using the PMK 300 with
the projector pole passing through the center
VersaTools
®
MDA EQ Series • Installation and Operation
Extron
MDA EQ Series
Mini Distribution Amplifier
Power Supply
Extron
PMK 300
Multi-product Projector
Mount Kit
2-7
Advertisement
Table of Contents
