Installation and Rear Panel, cont'd
Furniture mounting
Furniture-mount (under a desk or shelf) the DA AV EQ using
the optional mounting kit (part #70-077-01) as illustrated below.
Under-desk mounting the DA AV EQ
Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in
diameter in the table or desk at the marked screw locations. The
holes should be drilled from the underside or inside (concealed
side) of the furniture, where the amplifier will be located.
2-4
DA AV EQ Series • Installation and Rear Panel
Through-desk mounting
Mount the DA AV EQ through a desk or table, using the
optional mounting kit (part #70-077-02) as illustrated below.
Through-desk mounting the DA AV EQ
Mark the opening through which the unit will be
1.
mounted—approximately 1.8" by 8.9" (4.6 cm by 22.6 cm).
2.
Cut out the material from the installation area with a
jigsaw.
3.
Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in
diameter in the desk or table at the locations of the
mounting bracket screws. The holes should be drilled
from the underside or inside (concealed side) of the
furniture, where the amplifier will be located.
DA AV EQ Series • Installation and Rear Panel
2-5