Rack Mounting; Furniture Mounting - Extron electronics P/2 DA2xi MT User Manual

Rack Mounting

For optional rack mounting, mount the P/2 DA2xi MT on a 19-inch 1U rack shelf kit, a universal 1U 6-inch deep rack shelf kit, or a
universal 1U 9.5-inch deep rack shelf kit (see figure 4).
1. Remove the rubber feet (if installed) and mount the unit on the rack shelf, using two screws in opposite (diagonal) corners.
2. Install blank panels or other units to the rack shelf, as required.
3. Insert the shelf into the rack, and secure the shelf to the rack using the supplied machine screws.
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
Use 2 mounting holes
on opposite corners.
Figure 4. Rack Mounting Options

Furniture Mounting

For optional furniture mounting, mount the unit using an under-desk
mounting kit:
1. Attach the mounting brackets to the distribution amplifier
with the provided machine screws, as shown below.
2.
If feet were previously installed on the bottom of the unit,
remove them.
3. Hold the unit with the attached brackets against the underside
of the table or other furniture. Mark the location of the screw
holes of the bracket on the mounting surface.
4. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm)
deep in the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each
screw into the mounting surface until just less than 1/4 inch
of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets and
place the unit against the surface, with the screws through the
bracket slots.
7. Slide the unit slightly forward or back, then tighten all four
screws to secure the unit in place.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
4
1/2 Rack Width
False Faceplate
1/4 Rack Width
False Faceplate
(2) 4-40 x 3/16"
Screws
on the Extron website.
© 2003-2019 Extron Electronics — All rights re
All trademarks mentioned are the property of their respective owners.
Rack Shelf for
3.5" Deep Products
1/4 Rack Width
False Faceplate
Use 2 mounting holes
on opposite corners.
I N P
U T
M O
N I T
O R
Figure 5. Furniture Mounting Option
www.extron.com
served.
(2) 4-40 x
3/16" Screws
68-713-01 Rev. H
05 19