Download  Print this page

Care And Maintenance - Pride Victory XL-4 Owner's Manual

Victory xl-4.
Hide thumbs

Advertisement

X I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
n If equipped with pneumatic tires, always maintain a proper 30-35 psi tire pressure.
WARNING! It is important that 30-35 psi tire pressure be maintained in pneumatic tires at
all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of
control, and overinflated tires may burst. Failure to maintain 30-35 psi tire pressure in
pneumatic tires at all times may result in tire and/or wheel failure, causing serious personal
injury and/or damage to your scooter.
n Regularly inspect your scooter’s tires for signs of wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat, flooboard,
or tire tread. They will become dangerously slippery and result in personal injury and/or
damage to your scooter.
BATTERY TERMINAL CONNECTIONS
n Make certain that the terminal connections remain tight and uncorroded.
n The batteries must sit flat in the battery wells.
n The battery terminals should face the rear of the scooter.
WIRING HARNESSES
n Regularly check all wiring connections.
n Regularly check all wiring insulation, including the charger power cord, for wear or damage.
n Have your authorized Pride Provider repair or replace any damaged connector, connection, or insula-
tion that you find before using your scooter again.
ABS PLASTIC SHROUDS
n The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
n A light application of car wax will help the shrouds retain their high gloss.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorized Pride Provider.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
You do not need to lubricate these items, as they are all prelubricated and sealed
Victory XL-4 /RevC/June03
www.pridemobility.com
39

Advertisement

Table of Contents

   Also See for Pride Victory XL-4

Comments to this Manuals

Symbols: 0
Latest comments:
  • Dawn Kearns Dec 15, 2017 08:27:
    my status light is constantly blinking red Why?