I X . D I S A S S E M B L Y A N D A S S E M B L Y
The Victory XL-4 requires no tools for disassembly. Always disassemble or assemble your scooter on a
level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that
the disassembled sections of the scooter will take up more floor space than the assembled scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
1. Remove the key from the key switch.
2. Push down on the manual freewheel lever. See V. Your Victory XL-4. Putting your scooter in drive
mode may make it easier for you to maneuver the rear section because the drive wheels are stabilized.
3. Lift the seat up and off of your scooter.
4. Gently lift the rear shroud off of your scooter far enough to be able to disconnect the rear light har-
nesses. See figure 19. The rear shroud is held in place with a reusable fastener.
5. Unplug the large, white, 9-pin front-to-rear connector. See figure 20.
6. Unplug both battery harnesses from the battery harness connectors. See figure 20.
7. Loosen the battery straps, then lift both batteries from the battery wells.
Figure 19. Disconnect Lighting Harnesses
8. (If equipped) Disconnect the handbrake cable from the rear hub by pushing forward and holding the
brake release lever with your thumb. See figure 21. Lift the cable release hook free of the peg and slide the
handbrake cable free of its slot on the brake mount. See figure 21A. Move the cable safely out of the way.
PUSH BRAKE RELEASE
Figure 21. Brake Release Lever
BATTERY HARNESS CONNECTORS
Figure 20. Front-To-Rear Harness
LIFT UP THE CABLE
Figure 21A. Disengage Handbrake Cable