Entering The New Common Address; Change Baudrate Pc; Start Up; Reset Lamp Runtime - Barco R9001950 Owner's Manual

Entering the new common address

Only addresses between 0 and 1 are valid.
- with the digit keys on the RCU or the local keypad or
- pushing the cursor key é or ê until the new value is reached.

Change Baudrate PC

Start Up

1 Push the cursor key é or ê to highlight 'Change Baudrate PC'' (menu 1).
2 Press ENTER to display the Change Baudrate PC menu. The actual baudrate will be highlighed.
The following baud rates are available :
230400/115200/57600/38400/19200/9600/4800/1200
3 Push the cursor key é or ê to highlight the desired baudrate.
4 Press ENTER to select.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC

RESET LAMP RUNTIME

LAMP RUNTIME HISTORY
LAMP DIMMING
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Reset Lamp Runtime

When is it allowed ?

Reset lamp run time is only allowed when a new lamp is installed.
Start Up
1 Push the cursor key é or ê to highlight 'Reset Lamp Run Time'' (menu 1).
2 Press ENTER.
The following warning will be displayed (menu 2):
Risk of electrical shock. Reset lamp run time is reserved to qualified service personnel.
If you are not qualified, press EXIT to cancel the reset operation.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
LAMP DIMMING
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1

Lamp Run Time History

What can be done ?

Getting an overview of the different lamp run times
5976183 BARCOGRAPHICS 6500 31012001
CHANGE BAUDRATE PC
230400
115200
57600
38400
19200
9600
4800
1200
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
WARNING
-----------------------------------------------------
RISK OF
ELECTRICAL SHOCK
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
RESET LAMP RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
menu 2
Service Mode
9-5