Shelf Supports; Removing The Shelf Supports; Installing The Shelf Supports - AEG 47056VS-WN User Manual

26 www.aeg.com
• Clean stubborn dirt with a special
oven cleaner.
• Clean all oven accessories after each
use and let them dry. Use a soft cloth
with warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can destroy the nonstick
coating.
Stainless steel or aluminium ap-
pliances
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean
the oven control panel with the
same precautions.

Removing the shelf supports

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point
to the front!
2
1

11.1 Shelf supports

You can remove the shelf supports to
clean the side walls.
1.
Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
CAUTION!
Make sure that the longer fixing
wire is in the front. The ends of
the two wires must point to the
rear. Incorrect installation can
cause damage to the enamel.