AEG 47056VS-WN User Manual page 30

30 www.aeg.com
Oven capacity
Voltage
Frequency
13.1 Location of the appliance
You can install your freestanding appli-
ance with cabinets on one or two sides
and in the corner.
Minimum distances
Dimen-
sion
A
B
13.2 Levelling
Use small feet on the bottom of appli-
ance to set the appliance top surface
level with other surfaces.
Dimensions
74 l
230 V
50 Hz
B
A
A
mm
2
685
13.3 Anti-tilt protection
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it,
the appliance can tilt.
Your appliance has the symbol
shown on the picture (if applica-
ble) to remind you about the in-
stallation of the anti-tilt protec-
tion.
Make sure you install the anti-tilt
protection at the correct height.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the left side
of the appliance into the circular
hole on the bracket (see fig.). Screw
it into the solid material or use appli-
cable reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance (see
fig.).
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is
larger than the width of the appli-
ance, you must adjust the side meas-
urement to centre the appliance.