HP EliteOne 800 G1 Maintenance & Service Manual page 130

Table 6-5
Device Options
VGA Configuration
120 Chapter 6 Computer Setup (F10) Utility
Computer Setup—Advanced (for advanced users) (continued)
Allows you to set:
Turbo Mode (enable/disable). Allows you to enable and disable the Intel Turbo Mode feature,
●
which allows one core of the system to run at a higher than standard frequency and power if
other cores are idle. Default is enabled.
Printer mode (Bi-Directional, EPP + ECP, Output Only). ECP = Enhanced Capabilities Port, EPP
●
= Enhanced Parallel Port. Default is EPP+ECP.
Num Lock State at Power-On (off/on). Default is off.
●
Integrated Video (enable/disable). Use this option to disable the integrated video controller
●
when another video controller is present in the system. Default is enabled.
LVDS Panel Select (Auto-select, LG, Samsung). Use this option to select the display panel
●
manufacturer. When you change the LVDS setting to the installed panel type, the BIOS
reprograms the EDID with the correct data. You must set the panel before the Auto-select
setting functions correctly.
Integrated Graphics (Auto/Disable/Force) Use this option to manage integrated (UMA)
●
graphics memory allocation. The value you choose is allocated permanently to graphics and is
unavailable to the operating system. For example, if you set this value to 512M on a system
with 2 GB of RAM, the system always allocates 512 MB for graphics and the other 1.5 GB for
use by the BIOS and operating system. Default is Auto which sets memory allocation to 512
MB.
If you select Force, the UMA Frame Buffer Size option displays, which lets you set the UMA
memory size allocation between 32 MB and 1 GB.
Internal Speaker (does not affect external speakers). Default is enabled.
●
NIC PXE Option ROM Download (PXE, iSCSI, disabled). The BIOS contains an embedded
●
NIC option ROM to allow the unit to boot through the network to a PXE server. This is typically
used to download a corporate image to a hard drive. The NIC option ROM takes up memory
space below 1 MB commonly referred to as DOS Compatibility Hole (DCH) space. This space
is limited. This F10 option will allow users to disable the downloading of this embedded NIC
option ROM thus giving more DCH space for additional PCI cards which may need option
ROM space. The default will be to have the NIC option-ROM-enabled. Default is PXE.
SATA RAID Option ROM Download (enable/disable). The BIOS contains an embedded SATA
●
RAID option ROM for RAID support. This can be temporarily disabled to save DCH space.
Note that with the option ROM disabled, users will be unable to boot to hard drives in the
system while running in RAID mode. Default is disabled.
Multi-Processor (enable/disable). Use this option to disable multi-processor support under the
●
OS. Default is enabled.
Hyper threading (enable/disable). Use this option to disable processor hyper-threading.
●
USB Charging Port (enable/disable). Use this option to disable the USB charging port.
●
Displayed only if there is an add-in video card in the system. Allows you to specify which VGA
controller will be the "boot" or primary VGA controller.