Front Bezel And Display Panel - HP EliteOne 800 G1 Maintenance & Service Manual

Front bezel and display panel

Description
Front bezel
Assembly kit for non-touchscreen models without a webcam (includes webcam cover for bezel)
Assembly kit for touchscreen models without a webcam (includes webcam cover for bezel)
Touch panel kit, with integrated touch glass
Display panel – non-touchscreen models
Plastic frame for models with a webcam (does not include glass)
The front bezel is located on the front of the computer and is secured to the main system frame with 18
Torx screws.
Replacement bezels include the webcam shutter and capacitive sensor board. On models that do not
include a webcam, you must remove the shutter and install the webcam cover (Assembly kit) into the
slot in which the webcam would be installed.
Display panels require a backlight cable specific to the manufacturer. Make sure you use the backlight
cable packaged with the display panel.
To remove the front bezel:
1.
Remove the stand (see
2.
Prepare the computer for disassembly (see
3.
Remove the access panel (see
4.
Remove the optical drive (see
5.
Remove the top rear trim (see
6.
Remove the lower rear panel (see
7.
Remove the side panels (see
8. Remove the speakers (see
9. Remove the power button board (see
10. Remove the Torx screws that secure the bezel to the main system frame assembly, as follows:
18 total screws:
●
◦
◦
◦
◦
Stand on page
Access panel on page
Replacing the optical disc drive on page
Top rear trim on page
Side panels on page
Speakers on page
Left: 5 screws
Top: 5 screws
Right 5 screws
Bottom: 3 screw
36).
Preparing to disassemble the computer on page
40).
68).
Lower rear panel on page
92).
77).
Power button board on page
Spare part number
733500-001
733510-001
733511-001
735208-001
735207-001
733507-001
47).
73).
94).
Front bezel and display panel
34).
97