HP EliteOne 800 G1 Maintenance & Service Manual page 127

Table 6-4 Computer Setup—Power (continued)
Hardware Power
SATA Power Management – Enables or disables SATA bus and/or device power management.
Management Default is enabled.
PCI Express Power Management – Enables or disables Active State Power Management (ASPM) of
the bus. ASPM lets you set lower power modes that activate when the bus is not being used. Default
is ASPM Disabled.
S5 Maximum Power Savings – Turns off power to all nonessential hardware when system is off to
meet EUP Lot 6 requirement of less than 0.5 Watt power usage. Default is disabled.
Network Controller – Sets ASPM of the bus. ASPM lets you set lower power modes that activate
when the bus is not being used. Options are Disabled, LOs, L1, LOs and L1. Default is ASPM
Disabled.
USB 3.0 Controller – Sets ASPM of the bus. ASPM lets you set lower power modes that activate
when the bus is not being used. Options are Disabled, LOs, L1, LOs and L1. Default is ASPM
Disabled.
Thermal Fan idle mode—This bar graph controls the minimum permitted fan speed.
NOTE:
controlled.
This setting only changes the minimum fan speed. The fans are still automatically
Computer Setup (F10) Utilities
117